A Queensland farm reduces chemical use and costs by adopting a 36m Croplands WeediT Quadro sprayer, enhancing weed control efficiency.
Darren Jensen has 790 hectares (ha) in cultivation at Mount Murchison in Central Queensland.
He also has 230ha of grazing. Darren shares farms 120ha at Mount Murchison, 550ha at Jambin and 560ha at Thangool. Total cultivation is 2020ha.
His main crops include sorghum and mung beans in summer, and wheat and chickpeas in winter when the conditions are right.
Until 2019 Darren was spending a lot on agricultural chemicals, using a CaseIH Patriot 4430, so he was interested in finding out about saving costs by investing in spraying technology.
He looked at various options, including retrofitting Weedseeker 2 sensors to his Patriot sprayer.
However, he assessed there might be reliability issues using this on contoured country on a suspended boom, as the cameras need to be between 900mm and 1100mm from the ground to be the most efficient.
Darren also considered purchasing a second-hand 24m WeediT but found that this wouldn’t line up with his controlled traffic layout, with the first run in each paddock being only twice the planter width.
Finally, Darren decided on a 36m trailing Croplands WeediT Quadro.
The WeediT has a 6000L main tank to apply a residual herbicide, whilst the smaller 1100L tank can be used to spot spray simultaneously—it has 2 separate pumps and 2 lines.
Benefits
After investing in the WeediT, Darren has substantially reduced the amount of chemicals he is using, as he is now only spraying weeds and not doing a blanket spray. Sometimes, as little as 6% of the paddock requires spraying.
The WeediT costs $320,000. Darren estimates the payback will take approximately 3 years based on chemical savings alone, with the added advantage of being able to use different modes of action on hard-to-kill or resistant weeds, which are too expensive to use in a blanket spray.
The WeediT has 4 nozzles per camera at 20cm spacings along the boom. This means that larger weeds are seen on two cameras. This optimises the spraying zone and applies chemicals at different trajectories and higher rates, spraying larger weeds with 250 L/ha instead of 100 L/ha.
Darren has met a few challenges. To achieve the best savings in chemicals he had to target weeds when they’re small, meaning he was in the paddock more frequently. As well as this, the WeediT can only travel at 25kph on the road and 15kph in the paddock, which is slower than his old machine. It takes longer to complete a fallow spray than it used to.
Another problem Darren encountered was how to get over shrubs or other small obstacles in the paddock, as the boom couldn’t be lifted. In some instances, he has had to think about other ways of weed control in these areas.
Recommendations
Darren said that he had to make some changes to the way he did things, with his new sprayer being slower than a self-propelled one. However, he can target weeds before they get too big, which has led to massive savings in the amount of chemicals he has to use.
He said that for him it was not just great for the pocket, but for the environment too. But every farm is different, so he recommends doing the maths to see if time, money and savings make a similar investment worthwhile.
Last updated: 22 May 2026